PC300 Process Controller
Process control meter and industrial control system
FEATURES:
|
On this page:
• Process Controller Product Description |
Downloads (PDF):
• Process Controller Brochure
|
Process Controller Product Description
The Process Controller is reliable, accurate and suitable for measuring all types of 2 and 3 wire sensors with 4-20mA outputs including all of Global Water’s sensors. The controller comes pre-programmed for use with 10 different sensors and 14 engineering units. In addition, the PC300 can be programmed at the factory to monitor any type of custom sensor in any units selected by the customer. The controller can also monitor sensors with voltage outputs if specified at the time of purchase.
Display and Outputs
The LCD display shows the type of sensor that is being monitored, the data reading and the engineering units. The display also indicates if either relay has been triggered since last reset, which relay was triggered and whether the maximum or minimum limit was exceeded. Two separate relays are provided for controlling all types of external devices including samplers, alarms, mixers, pumps, control valves, floodgates and telemetry systems. Each relay is independently programmable to trigger on maximum and/or minimum levels in one of three different modes.
Installation
The Process Controller has many applications and therefore many installation solutions. The case is rugged and can be easily installed in a variety of conditions. Four screw holes are provided for securing the case to a wall, panel or different types of mounting hardware. While the case is watertight and will resist moisture, Global Water does not recommended that the PC300 be mounted outdoors without providing protection from continuous exposure to the weather.
Process Controller Specifications
Power: 90-240 AC or 12VDC
60mA DC normal, 150mA maximum
120uA average during sleep mode
Sensor Reading: 5 digits + decimal point
Analog Sensor Input: 4-20mA, 0-1V, or 0-5V
Input Resolution: 0.005mA, 0.24mV, or 1.2mV
Relay Contacts: Voltage: 30VDC
Current: 5A/30VDC
Max Capacity: 150W
Relay 1, 2nd Output: NPN to Ground, 1.0Kohm pull-up resistor
Relay 2, 2nd Output: NPN to Ground, Open-collector
Analog Output: 4mA minimum, 20mA maximum
Resolution: 0.005mA
Sensor Types/Units: Water Level (Feet/Meters), Temperature (ºF/ºC), pH (no units), Dissolved Oxygen (%), Turbidity (NTU/ppm), Conductivity (µS), Wind Speed (MPH/KPH), Wind Direction (º), Soil Moisture (%), Custom Sensor (any of the above, mA, mV or custom programmed units)
Sensor Data Range: 0.000 to 60,000 (60000 in the display with 4 different decimal point positions)
Relay Time Ranges: 1-60,000 seconds (16.7 hours)
Resolution: 1 second increments
Sleep Time Range: 1-240 minutes (4 hours)
Resolution: 1 minute increments
Operating Temperature: 32 to 122 °F (0 to 50 °C)
Storage Temperature: -4 to 158 °F (-20 to 70 °C)
Enclosure (WxHxD): 4.7×7.9×3 in (12x20x7.5 cm), NEMA 4X
Weight: 31oz (879 g)
Be the first to review “PC300-DS”